Product Description
Polyurethane adhesive for auto windscreen direct glazing. Direct glazing applied cold adhesive.The black colored one component applied cold polyurethane adhesive is designed for the direct-glazing of automotive glasses.
The product enables a 45min-1hr safe drive away once applied for customer convenience. DINITROL 9100 provides good adhesion on paints with excellent working characteristics. The fast curing, low conductive, high elasticity, OEM approved, and cold applied adhesive works on all vehicles whilst in ambient temperatures from -18 deg C to 45 deg C. Storage in closed packaging between 0 and 35 C.
*For complete instructions on how to use and apply the DINITROL glass bonding systems, please refer to the DINITROL AGR Training Manual.
*This product is a professional use product and should only be used by certified technicians. The seller highly recommends the buyer to use a professional auto glass installer for proper knowledge and use of this product. The buyer agrees to hold harmless seller and manufacturer for any liability with regard to the use and handling of this product. The buyer understands that by purchasing this product to use themselves without the use of a professional as recommend by the seller and manufacturer serious injury or death may result.*
DINITROL 538 Plus is a one-step primer for windscreen bonding. DINITROL 538 Plus is a solvent containing, physically and chemically drying black primer which promotes the adhesion between the glass/paint surface and the direct glazing adhesive and acts as a UV protection.
- One-step glass primer for the ceramic coating
- Pretreatment of RIM and paints
- Long life primer (no reaction within 3 months)
- Inhibits rust in small nicks and scratches
- Compatible with all DINITROL adhesive systems
Application temperature 5 C - 40 C - Application method felt / brush
Drying time > 5 min *
Adhesion with direct glazing Polyurethanes on glass-frit:
- with activator - good
- without activator - good
Shelf life 12 months
Important Note:
Due to its reactivity with moisture, the primer has to be used within 1 week after bottle has been opened (if properly sealed). DINITROL 538 Plus should not be used if the product has remained opened for an extended amount of time. Replace inner seal and cap tightly and immediately after each use to ensure maximum shelf life. This product is suitable for experienced professional users only.
Product Videos
Custom Field
Model Number D-9000
Bullet Point 5 (2) 310ml tube/cartridges and (1) 538 Plus (10ml) Primer Stick. Require cartridge style caulking gun to dispense.
Bullet Point 4 Fast Curing times Safe Drive Away Time - 45min- 1hr depending on temperature and humidity - check description for exact cure times.
Bullet Point 3 Method of use: The application of DINITROL 9000 requires a power caulking gun or 26:1 thrust ratio to properly dispense the product. The use of this product is suitable only for experienced users. Pre-tests are recommended for special applications.
Bullet Point 2 Directions: This urethane requires DINITROL 538 PLUS Primer. All bonding areas must be clean, dry, and free from contaminants. The glass must be pretreated with either the 538 Plus primer or Activator Plus.
Bullet Point 1 Benefits: - High Modulus - Non-Conductive - Fast Curing - Cold Applied - OEM Approved - Meets Applicaable FMVSS
