Product Description
Product is dated with best if used by October 14 2024PUR-505 can also be used with Dinitrol 538 Plus multifunction black primer for superior adhesion and 100 % UV blocking on all OEM and Aftermarket vehicle glass.PUR-505 is a one component cold applied, nonconductive urethane adhesive system.
Important Notes: Glass installation is not recommended at temperatures below 5 C (40 F) unless proper procedures are followed as stated in the DINITROL AGR Training Manual under Adverse Weather Conditions Section. Adhesives such as DINITROL 9100 or DINITROL 9000 should be used in these extreme temperatures unless glass is replaced in a heated shop an allowed to remain there until the appropriate Safety Drive Away Time as listed on the product TDS sheets have been met. *For complete instructions on how to use and apply the DINITROL glass bonding systems, please refer to the DINITROL AGR Training Manual.
2 tubes of urethane required for most windshield or back glass installations. 1 tube for most other glass installations.
This product requires a 26:1 thrust ratio caulk gun or better to properly dispense.
RH/TEMP | > 70% | > 50% | > 30% | > 10% |
> 85°F (30°C) | 3 hrs | 3 hrs | 3 hrs | 8 hrs |
> 73°F (23°C) | 3 hrs | 3 hrs | 4 hrs | 10 hrs |
> 60°F (15°C) | 3 hrs | 3 hrs | 5 hrs | 16 hrs |
> 50°F (10°C) | 5 hrs | 5 hrs | 12 hrs | 24 hrs |
> 40°F (5°C) | 9 hrs | 9 hrs | 18 hrs | 30 hrs |
*This product is a professional use product and should only be used by certified technicians. The seller highly recommends the buyer to use a professional auto glass installer for proper knowledge and use of this product.
The buyer agrees to hold harmless seller and manufacturer for any liability with regard to the use and handling of this product.
The buyer understands that by purchasing this product to use themselves without the use of a professionalas recommend by the seller and manufacturer serious injury or death may result.*