Product Description
Product is dated with best if used by December 14 2024PUR-505 can also be used with Dinitrol 538 Plus multifunction black primer for superior adhesion and 100 % UV blocking on all OEM and Aftermarket vehicle glass.PUR-505 is a one component cold applied, nonconductive urethane adhesive system.
Important Notes: Glass installation is not recommended at temperatures below 5 C (40 F) unless proper procedures are followed as stated in the DINITROL AGR Training Manual under Adverse Weather Conditions Section. Adhesives such as DINITROL 9100 or DINITROL 9000 should be used in these extreme temperatures unless glass is replaced in a heated shop an allowed to remain there until the appropriate Safety Drive Away Time as listed on the product TDS sheets have been met. *For complete instructions on how to use and apply the DINITROL glass bonding systems, please refer to the DINITROL AGR Training Manual.
2 tubes of urethane required for most windshield or back glass installations. 1 tube for most other glass installations.
This product requires a 26:1 thrust ratio caulk gun or better to properly dispense.
| RH/TEMP | > 70% | > 50% | > 30% | > 10% |
| > 85°F (30°C) | 3 hrs | 3 hrs | 3 hrs | 8 hrs |
| > 73°F (23°C) | 3 hrs | 3 hrs | 4 hrs | 10 hrs |
| > 60°F (15°C) | 3 hrs | 3 hrs | 5 hrs | 16 hrs |
| > 50°F (10°C) | 5 hrs | 5 hrs | 12 hrs | 24 hrs |
| > 40°F (5°C) | 9 hrs | 9 hrs | 18 hrs | 30 hrs |
* Application at or below 40°F is Not Recommended
*This product is a professional use product and should only be used by certified technicians. The seller highly recommends the buyer to use a professional auto glass installer for proper knowledge and use of this product.
The buyer agrees to hold harmless seller and manufacturer for any liability with regard to the use and handling of this product.
The buyer understands that by purchasing this product to use themselves without the use of a professionalas recommend by the seller and manufacturer serious injury or death may result.*
*This product is a professional use product and should only be used by certified technicians. The seller highly recommends the buyer to use a professional auto glass installer for proper knowledge and use of this product.
The buyer agrees to hold harmless seller and manufacturer for any liability with regard to the use and handling of this product.
The buyer understands that by purchasing this product to use themselves without the use of a professionalas recommend by the seller and manufacturer serious injury or death may result.*
Product Videos
Custom Field
Bullet Point 1 Benefits: - Primerless to Glass - High Viscosity - Excellent Working Time - Good Decking - Fast Curing - Short cut-off String - High Elasticity - Crash Test Proven to FMVSS
Bullet Point 2 This urethane doesn't requires the use of primer. All bonding areas must be clean, dry and free from all contaminates like oil, grease, release agents, etc. If there is no existing urethane on the pinchweld, apply 538 to the bonding area.
Bullet Point 3 DINITROL PUR-505 Requires power caulking gun or 26:1 thrust ratio to properly dispense. Product has very high viscosity and can not be dispensed without proper equipment. The use of this product is suitable only for experienced users.
Bullet Point 4 Fast Curing times Safe Drive Away Time - 3hr+ depending on temperature and humidity - check description for exact cure times.
Bullet Point 5 (12) 310ml tube/cartridges. Require cartridge style caulking gun to dispense.
Warranty 2 Years
Country of Manufacture Switzerland
Video 33684
